Walthers 933-26116 N Scale Turntable

[kornellred]

Does anyone have the printed instructions on how to operate the controller that comes with this particular turntable (933-26116)?  It has 4 7-segment LEDs centered near the top edge.  2 large arrows in red circles (one on either side - one arrow pointing up and the other down),  two rectangular buttons between the arrows (one labeled ESCAPE and the other one GO/SET).  And 2 smaller rectangular buttons (not labeled) to the right of the LED display.

I can make no sense of the Walthers website, which (ostensibly) can provide such information.

I could show my appreciation for any help given in some appropriate way.   Thanks!

[Rasputen]

Are you just looking for a copy of the instructions for the controller, or the installation instructions too?  I can scan them in but there are several documents.

Let's see if I can attach it below...

[Mark5]

Assuming this is the 933-2616, all the documentation is available for download here:

https://www.walthers.com/motorized-130-turntable-w-dcc-built-ups-assembled

[kornellred]

Oddly enough, there is/was  both a 933-26116 AND a 933-2616 turntable model.  The difference is the later model recognizes DCC and has a programmable address.  Both models use the same controller, so, thanks for the info!