Author Topic: Help!  (Read 833 times)

0 Members and 1 Guest are viewing this topic.

PiperguyUMD

  • Crew
  • *
  • Posts: 656
  • Respect: +1409
Help!
« on: September 05, 2020, 10:02:33 AM »
0
These where consecutive prints on the photon. I’ve never had anything fail like the hopper. Fresh FEP, and level job before the 3 boiler shells. I’d imagine if it when out of level or exposure issues, I wouldn’t have gotten the full support job. Any advice? TIA!







Mark W

  • Crew
  • *
  • Posts: 1988
  • Respect: +2125
    • Free-moNebraska
Re: Help!
« Reply #1 on: September 05, 2020, 10:38:05 AM »
0
Looks like a simple support failure to me, probably when it prints the end sil which is almost parallel with the build plate. 
Contact me about custom model building.
Learn more about Free-moNebraska.
Learn more about HOn3-mo.

garethashenden

  • Crew
  • *
  • Posts: 1834
  • Respect: +1209
Re: Help!
« Reply #2 on: September 05, 2020, 10:59:37 AM »
0
I've had similar issues where a large flat surface won't release from the film. Increasing the exposure time can help, or rotating the model so that the slope sheet isn't parallel with the build plate.

C855B

  • Crew
  • *
  • Posts: 10653
  • Respect: +2271
Re: Help!
« Reply #3 on: September 05, 2020, 11:36:43 AM »
0
Same here, a large flat surface inadvertently parallel with the FEP. Change the angle and that should fix it.

PiperguyUMD

  • Crew
  • *
  • Posts: 656
  • Respect: +1409
Re: Help!
« Reply #4 on: September 05, 2020, 12:07:39 PM »
0
I've had similar issues where a large flat surface won't release from the film. Increasing the exposure time can help, or rotating the model so that the slope sheet isn't parallel with the build plate.

Awesome! I hadn’t thought of that. Thank you!