Author Topic: Horse Barn Sss  (Read 2245 times)

0 Members and 1 Guest are viewing this topic.

gary60s

  • Crew
  • *
  • Posts: 260
  • Gender: Male
  • Charter member of CAMRRA
  • Respect: +55
Horse Barn Sss
« on: October 23, 2013, 10:12:51 AM »
0
Due to requests, I made the horse barn 6 stall instead of 8 stall. Footprint is 1 13/16” by 3”. It is a relatively easy build, and the hardest part is making the roof vents, since there are no commercially available ones.

Here is the link to the original plans:
http://bioengr.ag.utk.edu/extension/ExtPubs/Plans/6010.pdf

Choice of materials is up to you. It can be done in wood but sketches are based on styrene thicknesses. If you use another material adjust dimensions accordingly. Paint parts before assembly, except where the edges glue to other parts. For gluing styrene parts I recommend a plastic solvent type glue.

The building directions are in the sketches, and to make your build easier you can enlarge them to full size and print them out. Read directions in assembly sketches before cutting out parts as you may want to change some sizes or cut fewer, or additional, openings. Included sketches are: Overview sketches, Part templates, Shingle template, Assembly sketches, and pdf’s.

For operating man doors, use fine weave bridal veil material as hinges.

To print the part templates actual size, use the PDF's. Select best printer quality, set PDF zoom to 100%, and page scaling to "none" or actual size. Check your printed page to see that 3" lines are exactly 3" long. Once you have template printed, you can cut with scissors (leave a 1/8" border) and arrange on your material for maximum sheet usage. Part templates for siding are a mirror image, when needed, so that you can cut walls with siding side down (easier to cut). Be sure siding grooves are oriented correctly. Use rubber cement or Krylon Easy Tack Repositionable Adhesive to glue paper templates to your material and then just cut on lines. No measuring ! Paper comes off easily.

The building directions and materials are in the sketches, and to make your build easier, enlarge them to full size and print them out. Included sketches are: Overview sketches, Part templates, Assembly sketches, and pdf files.

Cut out parts carefully using a SERB (Single Edge Razor Blade) and straight edge, then follow assembly sketch directions.

Roofing material is up to you and Rich at rslaserkits has some good choices for a 3d effect.

























PDF links:
https://www.dropbox.com/s/34coax4s9mo9tuk/mhbpt1pdf.pdf
https://www.dropbox.com/s/rnj9ns9g381h0x3/mhbpt2pdf.pdf
Gary