« previous next »
Pages: [1]   Go Down

Author Topic: TCS AMD1/4 function pads  (Read 1460 times)

0 Members and 1 Guest are viewing this topic.

stuntman

  • Crew
  • *
  • Posts: 88
  • Gender: Male
  • Respect: +1
TCS AMD1/4 function pads
« on: August 09, 2009, 01:34:52 PM »
0
  Does anyone have a diagram for the function pads on a TCS AMD1?  The one on the TCS site is for an older version and I would like to put this in an Atlas Dash 8CW with the ditch lights.

                                       Thanks, Scott
Logged

Jim Starbuck

  • Crew
  • *
  • Posts: 1057
  • Respect: +3133
Re: TCS AMD1/4 function pads
« Reply #1 on: August 10, 2009, 04:57:05 AM »
0
The AMD1 is the older release and is only a 2 function board. Each function is occupied by the onboard LEDs for the front and rear lights and therefore no function pads.
The AMD1 was replaced with the AMD4 which is a 4 function board with two additional pads and auto adjusting BEMF.
HTH
Logged
Modutrak Iowa Division
Modutrak.com
Better modeling through peer pressure

stuntman

  • Crew
  • *
  • Posts: 88
  • Gender: Male
  • Respect: +1
Re: TCS AMD1/4 function pads
« Reply #2 on: August 11, 2009, 07:56:26 PM »
0
   Shoot!  I guess I should read the front of the package before I ask stupid questions. :-[   
Logged

Jim Starbuck

  • Crew
  • *
  • Posts: 1057
  • Respect: +3133
Re: TCS AMD1/4 function pads
« Reply #3 on: August 15, 2009, 07:47:54 AM »
0
Stuntman,
The only reason I knew this was because I emailed TCS one time and asked exactly the same thing.
Kind of a been there done that moment.
Logged
Modutrak Iowa Division
Modutrak.com
Better modeling through peer pressure
Pages: [1]   Go Up
« previous next »