Author Topic: Looking for a source .....  (Read 1243 times)

0 Members and 1 Guest are viewing this topic.

eja

  • Crew
  • *
  • Posts: 899
  • Gender: Male
  • Respect: +31
Looking for a source .....
« on: May 06, 2008, 06:25:41 PM »
0
Can anyone tell me where I can buy a sheets of .005 phosphor bronze material ?

I am looking to make a couple of contact strips from it, so I don't need a large amount.

Thanks in advance........

Chris333

  • Crew
  • *
  • Posts: 13451
  • Respect: +2761
Re: Looking for a source .....
« Reply #1 on: May 06, 2008, 06:37:12 PM »
0
I saw you ask over at Atlas and my own post has me with the Clover House catalog in my hands for another order.

But if you don't want to go with them I can say that I did the same thing to my LL SW using .005" brass with no problems.

sparky

  • Guest
Re: Looking for a source .....
« Reply #2 on: May 07, 2008, 09:11:16 AM »
0
McMaster-Carr has it.  Actually, there's not much they don't have.  A 6" X 50" sheet goes for $10.95.

Item number 9020K41.

http://www.mcmaster.com

engineshop

  • Crew
  • *
  • Posts: 882
  • Respect: +19
    • http://www.engineshop.org
Re: Looking for a source .....
« Reply #3 on: May 07, 2008, 11:26:32 AM »
0
My LHS has K&S brass sheets. There are about 5" x 8" and cost around $5.

eja

  • Crew
  • *
  • Posts: 899
  • Gender: Male
  • Respect: +31
Re: Looking for a source .....
« Reply #4 on: May 07, 2008, 07:39:36 PM »
0
Thanks engineshop ... that looks like the ticket ... it's even in the Walther's catalog !!