Sawmill Design/Build – Part 27 (Link to the print files);
You can find the print files on my thingiverse.com account
( HERE ).
If you take on this build keep in mind that this isn’t a commercial kit and you will end up doing some filing and fitting of parts. It is not a ‘snap-together’ kit. I could probably redesign some parts to work better but I’ve got what I need and no one is paying me anything and very few supporting the project so I’ll be moving on but you can see that it is possible to construct this if one takes their time.
The print files that are in this group for the sawmill constitute the exterior walls the two floor sections and also 3 floor supports. The following are pictures to help visualize putting the building together with this group of files.
.
.
.
.
The following images should show you where the different print files go.
.
.
.
.
.
You can find the print files on my thingiverse.com account
( HERE ).
.... to be continued.
=========================================
A link to this whole build
( HERE ).
Sumner
