diamond tread plate

[propmeup1]

Does any outfit make a diamond tread plate in sheets for N scale ? Like a Plastruct or Evergreen, even though i don't think the two i listed make it that small.   I'm building a couple of Reading T1s and their air pump deck was covered with diamond plate over the top and just a small area on the front.
Thank you,
Keith

[JanesCustomTrain]

Could this be of any help ?  BLMA N #250

Jane

[peteski]

Whatever you find will be out of scale. Correctly scaled diamond plate in N scale would be so fine that it would be almost invisible to the naked eye.

[nickelplate759]

Gold Medal Models #160-62

http://goldmm.com/nscale/gmnsctyp.htm


Approximately 1,000 square scale feet (or 2.375" by 2.375") of simulated steel non-skid deck plating for use in heavy industry, on fire trucks, factory platforms, etc. Supplied in four 32 scale feet long sections: one 16 scale feet wide, one eight scale feet wide, and two four scale feet wide. Relief-etched in .010" brass for extra detail.

[mmagliaro]

Big fan of the BLMA stuff, personally, if you can find it.
And since it's brass, it is very thin and the detail is crisper than you can get in styrene.

[propmeup1]

Ah yes, GMM. forgot to look them over and i even use his  other n etch sets.  Thank you.

[robert3985]

Whatever you find will be out of scale. Correctly scaled diamond plate in N scale would be so fine that it would be almost invisible to the naked eye.

"...almost..." being the operative word. 

Cheerio!
Bob Gilmore

[JanesCustomTrain]

Ah yes, GMM. forgot to look them over and i even use his  other n etch sets.  Thank you.

You're welcome.

Jane