Atlas SD7/9 Frames

[dmidkiff]

Will the guts of the newer Atlas SD7/9's fit into the older Atlas/Kato frame halves? Along with that, the newer shells should fit over the older frames halves, correct?

I ruined a newer frame while milling and figured I would get the older, heavier frame for a bit more strength and pulling capacity.

Thanks, Doug

[tehachapifan]

I seem to recall that the Atlas/Kato shell was slightly wider than the newer Atlas shell but I can't confirm this.

[nickelplate759]

Will the guts of the newer Atlas SD7/9's fit into the older Atlas/Kato frame halves? Along with that, the newer shells should fit over the older frames halves, correct?

I ruined a newer frame while milling and figured I would get the older, heavier frame for a bit more strength and pulling capacity.

Thanks, Doug

The new frame is narrower than the old (Kato) frame.  So, the new bodies will NOT fit on the old frames (I tried  )

[dmidkiff]

The new frame is narrower than the old (Kato) frame.  So, the new bodies will NOT fit on the old frames (I tried  )

Bummer. I knew the new frame was narrower, but didn't have a pair of shells to to examine. I was hopeful when reading Spookshow's review of the model as he noted that the newer shells were virtually identical to the old ones.

Thanks guys.

Doug

[mecgp7]

Doug,
Would you believe I have the exact opposite problem. I have the new Atlas SD7/9 frames, but want the older Kato made ones.
PM sent
Clint

[dmidkiff]

Clint,

I think we have the same problem. I have a new shell and want an old frame as well.

Doug

[daniel_leavitt2000]

I thought the shell was the same tooling, right? So a newer shell should fit the old chassis and vice versa.

[nickelplate759]

I thought the shell was the same tooling, right? So a newer shell should fit the old chassis and vice versa.

No, the shell is not the same tooling.  I have both and am quite certain (much to my disappointment).