New ESM video - G26 Mill Gons

[bbussey]

Finally created a video featuring the ESM Pennsylvania G26 mill gondolas.

Larger format on the ESM YouTube channel page and on the ESM website.

[up1950s]

I have and love them but is it the wheels that's causing the bobbing in the video ? Can we see the announcer in the video for a moment , that would be nice .

[tom mann]

Can we see the announcer in the video for a moment , that would be nice .

+1

[christoph]

I like these gondolas very much and was quite disappointed when the reissue was canceled.  More Pennsylvania versions or at least more numbers would be welcome.

Thank you Bryan for the great model.

[DKS]

Great model, well-done vid.

As an aside, I always thought it was GON-doh-lah, not gon-DOE-lah.

[bbussey]

I have and love them but is it the wheels that's causing the bobbing in the video ?

I think the nub from where the outer axle was connected to the runner was slightly rubbing against the coupler box.  Didn't catch that until the video was slow-mo'd and zoomed in.

Can we see the announcer in the video for a moment , that would be nice .

I don't believe she's open to that.  She's hot though!  

[Ian MacMillan]

I think the nub from where the outer axle was connected to the runner was slightly rubbing against the coupler box.  Didn't catch that until the video was slow-mo'd and zoomed in.

I don't believe she's open to that.  She's hot though!  

1. Must have been a flat spot...check those handbrakes!

2. No photos, no proof!...LIAR!

[bbussey]

2. No photos, no proof!...LIAR!

The owner of the voice from the XIH video also is hot.  I'm privileged to have friends that are the complete package.  Heh heh. 

[towl1996]

Nice video, but it could have been better with a PRR MOW gon in it. Any chance these will be released? Thanks

[wm3798]

You're a complete package...

[bbussey]

Nice video, but it could have been better with a PRR MOW gon in it. Any chance these will be released? Thanks

That would require reservations of greater than the 60 pieces per each PRR MOW road number that we received.  ESM has the ability to produce lower-than-usual minimums on an item, but 60 pieces is too low.  Unless the demand increases, the chances are non-existent.  I suspect that if a true G26S was offered in MOW colors it would be in greater demand, but it makes little sense to basically tool a new MOW car that only three roads had.  The G26A and G26C are future possibilities because they only require new slide inserts for the sides in the existing G26 tool and it opens up a few more schemes to do.

There still is a healthy quantity of G26 cars on hand.  Once the stock diminishes, there are more PRR ck schemes to do and I will attempt to piggyback in the N&W cars at that time.  But that is a long way off at this point.