HELP Athern 45-2 wont crawl

[jimlar19]

I have a Athern 45-2 engine ,and i am using Lentz DCC system and i cannot get this engine to crawl real slow like the outher atlas engines that i have, i have to set it on the second speed notch to get it to start moving and then it starts kind of fast, i have tried to change the voltage and speed settings in the CV, aney sugestions  HELP

Thanks

jim 

[wm3798]

I'm not sure what decoder you have there, but if it's Digitrax, CV 54 set to 1 will give you switching speed on F6.  It overrides any momentum you have, and drops the bottom end speed to next to nothing.  I program all my yard switchers to use that feature.

Lee

[sizemore]

I'm not sure what decoder you have there, but if it's Digitrax, CV 54 set to 1 will give you switching speed on F6.  It overrides any momentum you have, and drops the bottom end speed to next to nothing.  I program all my yard switchers to use that feature.

Lee

I like this! I can use this setting my VO1000.