TheRailwire

General Discussion => Weathering, Detailing, and Scratchbuilding => Topic started by: Iain on February 08, 2010, 01:41:27 PM

Title: Challenge for Chris
Post by: Iain on February 08, 2010, 01:41:27 PM

http://davesrailpix.com/odds/va/htm/ns03.htm

Do this in N.

Title: Re: Challenge for Chris
Post by: wm3798 on February 08, 2010, 02:11:46 PM

And make it run!

Title: Re: Challenge for Chris
Post by: Chris333 on February 08, 2010, 02:47:37 PM

I had it all drawn up in CAD then I lost everything on my hard drive. Yeah that's it.

Title: Re: Challenge for Chris
Post by: ednadolski on February 08, 2010, 03:53:27 PM

Quote from: Chris333 on February 08, 2010, 02:47:37 PM

I had it all drawn up in CAD then I lost everything on my hard drive. Yeah that's it.

No more excuses:

http://www.salvagedatarecovery.com/
http://www.datarecovery.net/

Title: Re: Challenge for Chris
Post by: Bob Bufkin on February 08, 2010, 04:02:12 PM

You think this coudl be used?

http://www.katomodels.com/product/nmi/tlr0600_e.shtml

Title: Re: Challenge for Chris
Post by: Chris333 on February 08, 2010, 04:21:00 PM

http://www.salvagedatarecovery.com/

$179 to activate it  :o

There is no data I need that badly.

Title: Re: Challenge for Chris
Post by: SquirrelHollow on February 08, 2010, 04:38:07 PM

NW-2 Trucks, and a custom 6mm Motor mechanism would probably be doable.

Title: Re: Challenge for Chris
Post by: sizemore on February 09, 2010, 12:58:58 AM

Quote from: Chris333 on February 08, 2010, 04:21:00 PM

http://www.salvagedatarecovery.com/

$179 to activate it  :o

There is no data I need that badly.

Add the drive as a slave install OS to new drive installed as master.

The S.